Iron Instructions

This is a general guide on how to use a household iron with your Print Magic DTF Transfers. Scroll below to get a step by step guide on how to apply!

What You'll Need:

Print Magic DTF Transfer

HOUSEHOLD IRON

parchment paper or teflon

1. Prep & Place

Ensure your Cricut EasyPress is on a flat, heat-resistant surface or table.
Place a clean, flat surface (like a pressing mat) beneath the item you’re pressing.
Line your transfer up on your garment and your prepped to press!

2. Pre-Heat & Press

Turn on your Cricut EasyPress and set the temperature to 310°F (154°C). Allow it to preheat.
- Note: You may have to increase the temperature to 315°F – 325°F.
With firm, even pressure, press the transfer for 15 seconds.

3. Peel The Film

After pressing you can now remove the film right after you press!
- Note: If you feel like the film is not giving, then wait until the transfer is completely cool to the touch and then cold peel and proceed to the next step.

4. Final Press

After the film is removed, put a piece of teflon(shiny finish) or a piece of parchment (matte finish) on the design.
Press for an additional 5 seconds and admire your work!

Final Care instructions:

Wait 24 hours before washing the garment.
Wash inside out on a cold cycle; tumble dry on low or hang to dry for longer-lasting designs

ORDER YOUR TRANSFERS NOW

Get started with our magical transfers. Whether you are a hobbyist or a screen print shop we have solutions for all. Create your wholesale account now or upload your gang sheet.